CAS: 26471-62-5 | 分子式: C9H6N2O2 | 分子量: 174 | EINECS号: 247-722-4 |
折射率
|
1.5660 to 1.5700
|
---|---|
LogP
|
3.43 at 22℃
|
溶解度
|
miscible with Ether,Acetone,Benzene
|
形态
|
clear liquid
|
颜色
|
Colorless to Light yellow
|
气味 (Odor)
|
Sharp, pungent odor
|
水溶解性
|
124mg/L at 25℃
|
(IARC)致癌物分类
|
2B (Vol. 39, Sup 7, 71) 1999
|
EPA化学物质信息
|
安全说明
|
|
---|---|
危险品运输编号
|
2078
|
危险性描述
|
|
海关编码
|
29291090
|
毒害物质数据
|
|
毒性
|
A designated hazardous waste (EPA). It is a colorless to
yellow solid, melting at about 20°C. TDI and MDI (diphenylmethane diisocyanate) are used in the manufacture of polyurethane foams by reaction with polyhydroxy compounds. These
foams are used for insulation, upholstering, etc. Exposure is
commonly by inhalation of the vapor. Both TDI and MDI can
cause irritation of eyes and mucous membranes, in severe
cases leading to pulmonary edema. Sensitization to TDI is
common and frequently rapid, leading to an allergic reaction
and some loss of lung function. In the United Kingdom, the
threshold limit value is 0.02 ppm for not more than 20 min, or
0.005 ppm for 8 h.
|
危险性符号(GHS)
|
|
---|---|
防范说明
|
化学性质 |
无色透明或淡黄色易燃液体。有强烈的刺激气味。 与乙醇(分解)、二甘醇、乙醚、丙酮、四氯化碳、苯、氯苯、煤油、橄榄油混溶。
|
---|---|
生产方法 |
1.由2,4-二氨基甲苯与光气作用制得。先将固体二氨基甲苯溶于氯化苯中,在搅拌下升温至70℃得二氨基甲苯氯苯溶液,将回收光气化的氧化苯,放入低温光气锅中,补加一定液体光气后,在搅拌下滴加配好的二氨基甲苯溶液,在40℃进行光气化,再将低温光气化的物料放入高温锅中进行高温光气化,边升温边通气,约4h,反应一般在120~125℃进行;反应完毕,经用氮气赶气、蒸馏、精馏而得。 |
用途 |
用作制造聚氨酯软泡沫塑料、涂料、橡胶及粘合剂的原料
|
用途 |
用于制造聚氨酯泡沫塑料及橡胶、绝缘漆及粘合剂等
|
类别 |
有毒物品
|
毒性分级 |
中毒
|
急性毒性 |
口服-大鼠 LD50: 4130毫克/公斤; 口服-小鼠 LD50: 1950毫克/公斤
|
刺激数据 |
皮肤-兔 500 毫克 重度
|
爆炸物危险特性 |
与空气混合可爆
|
可燃性危险特性 |
明火可燃; 受热放出有毒氧化氮气体
|
储运特性 |
库房通风低温干燥; 与食品原料分开储运
|
灭火剂 |
水、二氧化碳、砂土、泡沫
|
职业标准 |
TWA 0.02 毫克/立方米; STEL 0.07 毫克/立方米
|